Went out fishing on the lake earlier last week and changed my mind of how I wanted the boat to be setup. I decided to cut out the center bench and just make one long flat floor from the rear bench all the way forward. Two pedestal seats, one front and one towards the rear. And then two storage...
I have a pneumatic rivet gun from harbor freight. It is fantastic and totally worth the money if you have a use for it. I am a auto mechanic and I have had it for years, way better than even a large manual rivet gun. I think it was like $50 or $60.
Fixed the leak today by pulling out the transom bolts and sealing them again. Also made the cardboard template and cut the floor for the front section and then it started to rain. Tomorrow I think I'll go and get some carpet and cover the two floor sections I have cut just because it is supposed...
By the way, we did take the boat for a quick ride on Friday despite the leak. I changed the trim position since the last ride as the motor was initially too low. We hit 26mph with two of us and just the minimum safety gear!!! Unbelievable that this thing goes that fast with just a 15hp, but it...
Took the boat out on Friday and it developed a leak from the transom. I towed the boat up to work and went out up there with a coworker. As soon as it went in the water it was leaking. The wood was replaced by the previous owner and was ok till then. Not sure if the bouncing on the road with the...