tonynoriega
Well-known member
So as I am out in my garage and contemplating my upcoming paint job... I looked at the side of the hull, along the "fin" or wing...
Where I removed the benches there are 5 rivets that hold them to the hull...and only 3 that hold the seat to an angled bracket which had the 5 holes.... realizing I should have only removed the 3 and left he bracket untouched and in tact...
rookie mistake.
what is going to be my best option to securing the bracket and bench back to the hull...
I have replaced about 20 rivets in the bottom already with some closed end blind rivets and some 3M5200.... can I do that here as well?
Not pretty, but not sure what else I can do...
SS nuts and bolts?
Oh, this made my head hurt and heartache...
Where I removed the benches there are 5 rivets that hold them to the hull...and only 3 that hold the seat to an angled bracket which had the 5 holes.... realizing I should have only removed the 3 and left he bracket untouched and in tact...
rookie mistake.
what is going to be my best option to securing the bracket and bench back to the hull...
I have replaced about 20 rivets in the bottom already with some closed end blind rivets and some 3M5200.... can I do that here as well?
Not pretty, but not sure what else I can do...
SS nuts and bolts?
Oh, this made my head hurt and heartache...