Tunnel hull

[red450r]

Has anyone here installed their own tunnel? i emailed Outboard Jets and they sent me a blue print, has anyone else used their design?
Thanks,
Ethan

 

[susqy]

Yes I have, I used there pattern to have one installed in a 17x60 Odyssey river rave with a 90/65 Merc. The boat works very very well with it.

I have since sold I kinda miss her

 

[red450r]

Thanks man, you have any pictures of the finished product?

 

[susqy]

Sorry, this is the only pic I have left on my pc, I must have deleted when I sold. The fab shop that welded in mine followed the width and length of the blue prints and the Height was 2 1/2 at rear.

 

[red450r]

thanks for uploading that, did you buy the fins on the foot from outboard jet or make them?

 

[susqy]

Those are a boughten set for James River Jets, they are made from Poly. Direct the water well and protect from minor contact too. Cost about the same as an aluminum bolt on set from OB jet.

 

[red450r]

thanks ill give them a call once i get the tunnel in