Bought a new 20 hp motor for my 14' Mirro-craft. The original motor was bolted on the transom. The new motor will also be bolted but the the holes will be 1" above the old holes. Can I fill the old holes with epoxy without loosing any strength in the transom?
TinBoats.net
The original aluminum boat site!
Existing motor mounting bolt holes in transom...
- Thread starter tucker99
- Start date
Help Support TinBoats.net:
Sure can, go for it!
CedarRiverScooter
Well-known member
- Joined
- Nov 13, 2014
- Messages
- 1,522
- Reaction score
- 5
A technique I use is to cut up some fiberglass into small bits, about a cup's worth. Then mix that with your epoxy & you get 'tiger hair;'. Makes great hole filler. Push it in with a big nail or pencil. Maybe tape the back side so it doesn't run out.
Many different brand motors use a different bolt hole pattern, i.e., there is no industry standard.ericman said:
nccatfisher
Well-known member
- Joined
- Feb 4, 2013
- Messages
- 694
- Reaction score
- 4
Actually there is a BIA standard for bolt on motors and USUALLY under 40 HP all are supposed to be the same. Over 40 I think all were pretty much the same, but Yamaha was much larger on their smaller motors to two years ago. I think they downsized their pattern around then.
Similar threads
