So my rear anchor light wasn't working. I realized one of the wires in the based was not making a good contact and had it working but figured I'd just replace the base anyway.
I replaced the base, not realizing til after I was done, that I had left the switch on for the nav lights so the power was on. When I went to test the new base, I noticed it was switched on but the light in the switch was no longer illuminated. Assuming the light isn't on since it's not getting power from being shorted.
If I'm looking at this right, I probably popped one of these fuses under the dash.
Any easy way to figure out which fuse would go to it? This sound like the correct diagnosis overall? I'm an electrical amateur.
Sent from my SM-G975U using Tapatalk
I replaced the base, not realizing til after I was done, that I had left the switch on for the nav lights so the power was on. When I went to test the new base, I noticed it was switched on but the light in the switch was no longer illuminated. Assuming the light isn't on since it's not getting power from being shorted.
If I'm looking at this right, I probably popped one of these fuses under the dash.
Any easy way to figure out which fuse would go to it? This sound like the correct diagnosis overall? I'm an electrical amateur.
Sent from my SM-G975U using Tapatalk