lowe
Well-known member
Should of put this in the other post, but it is separate from the boat mod I guess. The guy I bought my boat from has the runners on the trailer all out of wack. One of the board is flat, while the other one is angle outwards. For example, say you were standing at the back of your trailer looking towards the front as a sense of the way the board is running. The board on the right is flat, while the one of the left is angled towards the trailer tire. With that I mean the is slopes from right to left towards to outside of the trailer.
I don't know if my boat would considered a V Bottom or Flat Bottom or a little bit of both. It starts off like a V and then flattens where the floor starts.
My question is how should I put the loading runners on my trailer? Flat, or at an inward angle? Also how wide apart should the runners be, or where should they strike the boat bottom at? Right now, when I load my boat, it gets too far over to the right and sits somewhat crooked on the trailer. I was just looking at it, and the passenger side of the boat is against the trailer fender, while the driver's side of the boat is not even close. I think it loads crooked because of the the way the runners are installed on the trailer.
Any help is appreciated. Thanks
I don't know if my boat would considered a V Bottom or Flat Bottom or a little bit of both. It starts off like a V and then flattens where the floor starts.
My question is how should I put the loading runners on my trailer? Flat, or at an inward angle? Also how wide apart should the runners be, or where should they strike the boat bottom at? Right now, when I load my boat, it gets too far over to the right and sits somewhat crooked on the trailer. I was just looking at it, and the passenger side of the boat is against the trailer fender, while the driver's side of the boat is not even close. I think it loads crooked because of the the way the runners are installed on the trailer.
Any help is appreciated. Thanks