fugeman
Member
Can't get my transducer to read through the hull or on the right side of the transom. I've got it mounted so that it is always under water but can't figure out why it won't read. Also I can't get my boat to trim no higher than just a few inches. It starts porpoising before I can even get half trimmed out. It's got a whale tail on it but still does it. I've heard that is was because most all tin boats have a slight upper roll on the bottom of the boat right before it meets the transom. My boat is an 18 foot PolarKraft with a 60 horse Yamaha. Any suggestions would be appreciated. Thanks