Sinkingfast
Well-known member
- Joined
- Oct 5, 2014
- Messages
- 262
- Reaction score
- 17
Never liked the "modern" suck fuel from a tank setups but made due. I am at a point in my boat project where I might go to a two line pressure tank setup with a permanent 12 gal tank. But i have some questions before deciding.
Where is the pressure safety release vent to, if there is one.
If there is one, what is it set at.
I must use a check at the pulse port and should be low mass as to move at 84hz? Not sure...
What is normal operating pressure.
If I tilt up the motor under pressure will the carb float drop allowing fuel to spill.
Yes I will do some research but this is part of it.
Just got 4 inches snow...not happy
Oh, and where to put primer bulb in fuel line..thanx
Where is the pressure safety release vent to, if there is one.
If there is one, what is it set at.
I must use a check at the pulse port and should be low mass as to move at 84hz? Not sure...
What is normal operating pressure.
If I tilt up the motor under pressure will the carb float drop allowing fuel to spill.
Yes I will do some research but this is part of it.
Just got 4 inches snow...not happy
Oh, and where to put primer bulb in fuel line..thanx