On my current project, the mod v jon has a factory alum deck in the bow, common on most jons I've seen. I have been mocking up trolling motor, anchor, nav light, ff, etc positions and feel that it will need reinforcement. The metal is 0.100" but does not have any ribs. Numerous ideas/methods have crossed my mind. The biggest hurdle is working through the available hatch space.
I am thinking a small section of plywood backer for the trolling motor, and a pair of L channel (T) or square tubing followed by a couple of verticle supports. The supports placement will be slightly tricky with the mod v bow, and may need some floor support. When finished, will stuff some additional foam in the bow, before closing off the hatch. The new deck will prevent access. I do have a round deck access hatch that will be installed, but will only be good to reach wiring, etc.
I am interested in how others have solved a similiar issue. Pictures would be great, if you have them. thx.
I am thinking a small section of plywood backer for the trolling motor, and a pair of L channel (T) or square tubing followed by a couple of verticle supports. The supports placement will be slightly tricky with the mod v bow, and may need some floor support. When finished, will stuff some additional foam in the bow, before closing off the hatch. The new deck will prevent access. I do have a round deck access hatch that will be installed, but will only be good to reach wiring, etc.
I am interested in how others have solved a similiar issue. Pictures would be great, if you have them. thx.