I have used these clamps for quite sometime and what i did was
to replace the wingnut with a regular nut and then use a hacksaw
and cut the threaded rod down to where i could put a socket on it
and tighten it with a ratchet. (I use a deep socket)
It made it much easier to to tighten the clamp to the bench. When
I have to remove it all I have to do is loosen the nut just a little and
pull it off. Hope this helps. Scott
to replace the wingnut with a regular nut and then use a hacksaw
and cut the threaded rod down to where i could put a socket on it
and tighten it with a ratchet. (I use a deep socket)
It made it much easier to to tighten the clamp to the bench. When
I have to remove it all I have to do is loosen the nut just a little and
pull it off. Hope this helps. Scott