vahunter
Well-known member
Hey guys,
I recently bought a Weldbilt 1548V, new, with the aluminum diamond plate floor. I love this boat but the only thing I'm unhappy about are the notches around the ribs not being clean cut nor even. The floor is riveted in so I was gonna mark the areas that need attention before I drill em out. While its off I was thinking to put adhesive weatherstripping where the floor and ribs touch to maybe help dampen the floor rattle. Oooorrr...spray 3m rubberized undercoating everywhere that the floor covers (including the hull) to help dampen as well. Anyone have any input or ideas? I know an aluminum is always loud but i duck hunt so while I have the floor off at least make an attempt.
I recently bought a Weldbilt 1548V, new, with the aluminum diamond plate floor. I love this boat but the only thing I'm unhappy about are the notches around the ribs not being clean cut nor even. The floor is riveted in so I was gonna mark the areas that need attention before I drill em out. While its off I was thinking to put adhesive weatherstripping where the floor and ribs touch to maybe help dampen the floor rattle. Oooorrr...spray 3m rubberized undercoating everywhere that the floor covers (including the hull) to help dampen as well. Anyone have any input or ideas? I know an aluminum is always loud but i duck hunt so while I have the floor off at least make an attempt.